Wavetek 39A Spécifications télécharger pdf (Page 31)

User Manual 301/302

/* Turn on the channel 2 main output. */

:OUTPut ON;

If the above commands are executed correctly, a square waveform

will be seen on your oscilloscope at the channel A and B outputs

connector.

Controlling the

301/2 Using

WaveWiz

To repeat the above sequence of commands using WaveWiz, perform

the following sequence of steps having started WaveWiz running.

Open the Instrument Front Panel by clicking on the button

Reset the Model 301/302 to its default condition as listed in Table 3-1.

By clicking on the *RST button on the System tab

Figure 3.2 Reset button on the System Tab

Select the Standard tab, and on both channel A and B, change the

output waveform to square; change the frequency to 20 MHz;

change the output voltage to 2.0 V; and the offset to 0.5V by

clicking the relevant buttons and entering data into each relevant

data entry box (see Figure3.3 below). The command is executed

either by clicking OK, which will close the instrument control panel,

or by hitting the tab key on the PC keyboard, which will leave the

instrument control panel open for further control changes.

Configuring The Instrument

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 136 137

Pas de commentaire

Wavetek 39A Spécifications Page 31