Wavetek MS1300 Spécifications télécharger pdf (Page 65)

2-23

NoteNote

Note

The channels that appear on this screen are the same ones that you

selected when you configured your tilt channels. (see SELECT TILT

CHANNELS).

MOVING THE MARKERMOVING THE MARKER

MOVING THE MARKER

A vertical marker appears over the currently selected carrier. The

channel number, type and label appear in the upper right-hand portion

of the screen. The frequency and level of the selected carrier can be

seen directly beneath the graph. You can use the left or right arrows to

select the previous or next carrier.

ADJUSTING THE REFERENCE LEVELADJUSTING THE REFERENCE LEVEL

ADJUSTING THE REFERENCE LEVEL

The reference level setting is displayed above the graph. This is the

level at the very top line. You can adjust the reference level

using the up and down arrows. When you press the SHIFT + keys,

your CLI-1450 automatically sets the optimum reference level for

you.

ADJUSTING THE SCALEADJUSTING THE SCALE

ADJUSTING THE SCALE

The scale setting is displayed above the graph. You can adjust the

scale to provide the best view of the carrier levels by pressing the

soft key. A new set of soft keys appears. Use the and soft

keys to increment and decrement the scale value. Press the soft

key when you have finished.

CHECKING LIMITSCHECKING LIMITS

CHECKING LIMITS

You can verify that the carrier levels are within limits. First, you need

to tell your CLI-1450 which test point you are at. This determines

which set of limits are used. Press the soft key to sequence

through the available test points. The test point that you have

selected is represented in the upper portion of the screen by one of

the following icons:

Subscriber Drop

Ground Block

Tap

Custom (User Defined )

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 100 101

Pas de commentaire

Wavetek MS1300 Spécifications Page 65