Wavetek MS1300 Spécifications télécharger pdf (Page 23)

1-17

Measurement Configuration

TEMPERATURE UNITSTEMPERATURE UNITS

TEMPERATURE UNITS

Selects the units in which temperature measurements are displayed

and printed. You can select between; °C or °F.

SIGNAL LEVEL UNITSSIGNAL LEVEL UNITS

SIGNAL LEVEL UNITS

Selects the units that will be used for all signal level measurements.

You can select between; dBmV, dBµV and dBm.

PROBE COMPENSATIONPROBE COMPENSATION

PROBE COMPENSATION

This can be used to compensate for losses associated with probe

points found on certain amplifiers. You can enter a value between

-99.9 and +99.9 dB. Probe compensation is added directly to signal

level measurements. The compensation value is indicated in the

upper left-hand corner of the measurement screens. There is no

indication, however, if the compensation value is zero.

ImportantImportant

Important

The PROBE COMPENSATION value does not affect IN-

STALLATION mode. Level measurements made while

checking an installation are uncompensated.

FREQUENCY TUNING STEP SIZEFREQUENCY TUNING STEP SIZE

FREQUENCY TUNING STEP SIZE

This setting affects the increment/decrement step size when you are

tuning the frequency using the left and right arrows. You can select a

value between 25kHz and 100MHz in steps of 25kHz.

SCAN AUDIO CARRIERSSCAN AUDIO CARRIERS

SCAN AUDIO CARRIERS

Select YES if you want to see the audio carriers in the full scan screen.

You can achieve a faster scan by omitting the audio carriers.

SCAN SCRAMBLED CHANNELSSCAN SCRAMBLED CHANNELS

SCAN SCRAMBLED CHANNELS

Select YES if you want to see scrambled channels in the full scan

screen.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 100 101

Pas de commentaire

Wavetek MS1300 Spécifications Page 23