Wavetek MS1300 Spécifications télécharger pdf (Page 63)

2-21

ImportantImportant

Important

You can choose which carriers appear on this screen when you config-

ure your channel plan (see SELECT TILT CHANNELS).

MOVING THE MARKERMOVING THE MARKER

MOVING THE MARKER

You can view up to six carriers. A vertical marker appears over the

currently selected carrier. The channel number, type and label

appear in the upper right-hand portion of the screen. The frequency

and level of the selected carrier can be seen directly beneath the

graph. You can use the left or right arrows to select the previous or

next carrier.

SELECTING THE LOW AND HIGH CARRIERSSELECTING THE LOW AND HIGH CARRIERS

SELECTING THE LOW AND HIGH CARRIERS

Notice that the bars representing the low and high pilots are solid and

all others are dim. You can select which carriers are used for the tilt

measurement. To select the low pilot carrier, move the cursor to the

desired carrier and press the soft key. To select the high pilot

carrier, move the cursor to the desired carrier and press the soft

key. The tilt measurement is calculated from the low and high pilot

carriers that you have selected.

ADJUSTING THE REFERENCE LEVELADJUSTING THE REFERENCE LEVEL

ADJUSTING THE REFERENCE LEVEL

The reference level setting is displayed above the graph. This is the

level at the very top line. You can adjust the reference level using the

up and down arrows. When you press the SHIFT + keys, your CLI-

1450 automatically sets the optimum reference level for you.

ADJUSTING THE SCALEADJUSTING THE SCALE

ADJUSTING THE SCALE

The scale setting is displayed above the graph. You can adjust the

scale to provide the best view of the carrier levels by pressing the

soft key. A new set of soft keys appears. Use the and soft

keys to increment and decrement the scale value. Press the soft

key when you have finished.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 100 101

Pas de commentaire

Wavetek MS1300 Spécifications Page 63