Wavetek MS1300 Spécifications télécharger pdf (Page 46)

2-4

NoteNote

Note

The characteristics for each type of antenna are programmable. Be

sure that you have enabled all the antenna types that you want to use.

The soft key is only available if there is more than one enabled

type. (see EDIT ANTENNA TYPES in the Leakage Configuration

section).

NoteNote

Note

The antenna selection is only useful for field strength measurements.

If the measurement units you have selected result in an absolute

measurement, the soft key will not be available.

ENTERING THE LEAKAGE DISTANCEENTERING THE LEAKAGE DISTANCE

ENTERING THE LEAKAGE DISTANCE

If you find a leak in an inaccessible area, you can enter the estimated

distance from the leak and your CLI-1450 will calculate what the

equivalent field strength would be at the reference distance. These

measurements are adequate for grading leaks you have found and

prioritizing your repair schedule based on leak severity. You should,

however, always perform regulation compliance measurements at the

required reference distance.

ImportantImportant

Important

The most accurate and repeatable measurements are made using a

dipole antenna located at the required reference distance

. .

. This is

the only method recommended by WWG for making regulation compli-

ance measurements.

The leakage distance appears in the upper right-hand corner of the

display. To enter a different value, use the numeric keys followed by

the key.

NoteNote

Note

This feature is only useful when performing field strength measure-

ments. If the measurement units you have selected result in an

absolute measurement, the leakage distance will appear dimmed.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 100 101

Pas de commentaire

Wavetek MS1300 Spécifications Page 46