Wavetek MS1300 Spécifications télécharger pdf (Page 25)

Step 3

You can tell microStealth what frequency to stop searching

for channels. This will save time when building the plan.

The frequency you enter should be just above the highest

channel on your system. If you are not sure what the

frequency of your highest channel is, just use the default

value that appears in the edit box. If you have entered a

value, be sure to terminate your entry with the key.

Press the soft key to begin building the plan.

Upon pressing the soft key, microStealth begins searching your

system for active channels. A bar graph indicates the percentage of

the channels searched. After the plan has been built, press the

soft key to return to the Channel Plan Configuration screen.

EDIT CHANNEL PLAN

You can edit various parameters for each channel. Press the

key to edit the channels. A list of all the channels in the plan

appears.

A check mark appears in the left-hand column when the channel is

enabled. When you built the channel plan, MicroStealth automati-

cally enabled all the channels it found to be active on your system.

You may want to verify that all your channels have been correctly

enabled. Use the soft key to enable/disable the channel

highlighted in the list.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 70 71

Pas de commentaire

Wavetek MS1300 Spécifications Page 25