Wavetek 3ST Spécifications télécharger pdf (Page 89)

5-6

IMPORTANT: Reverse Sweep should be disabled when there are

no 3SR units being used with the Reverse Sweep

option. This will optimize the update rate of the

Forward Sweep. It should also be disabled if you

are using the 3HRV for reverse sweeping.

5.2.2 Select the Frequency of the Reverse Telemetry Carrier

This is the frequency at which 3SR units with the Reverse Sweep

option will transmit telemetry data. Optimally this will be in a

portion of the reverse frequency band with at least 1 MHz free, and

at best case, in the high end of the return band to avoid potential

interference from ingress.

IMPORTANT: The frequency the reverse telemetry carrier should

be carefully selected such that it will not interfere

with any existing carriers on the reverse plant.

5.2.3 Access Reverse Sweep Plans

Reverse Sweep Plans are used to define the frequencies at which

sweep points will be inserted by 3SR units with the Reverse Sweep

option. To access Reverse Sweep Plans, select the “Reverse Sweep

Plans” option and then press the ENTER key.

5.2.4 Selecting a Reverse Sweep Plan

The Reverse Sweep Plan screen presents a list of all Reverse Sweep

Plans stored in memory. The current active Reverse Sweep Plan is

displayed beneath the list of plans. Use the up or down arrow to

select the plan you want, then press the Load soft key to load the

selected plan into memory for use. Press the EXIT soft key to return

to the previous screen or the SWEEP key to begin sweeping.

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 101 102

Pas de commentaire

Wavetek 3ST Spécifications Page 89